OvrX Installation Page

Tools Required.

Hammer and tapping block

Circular saw or jigsaw

Tape measure and carpenter pencil

Carpenter's square and pull bar

1/2" Spacer Boards

OvrX recommended leveling kit

Step 1. After clearing floor space, check floor for imperfections. If there are imperfections greater than 1/4", we recommend that you use a self-leveling compound to fix them. Once this is done, lay down spacer boards in one corner, provide a minimum 1/2” expansion gap around perimeter of floor.

Step 2. Align the first tile with the two groove sides against the spacer boards. Add additional panels in one direction until you cannot fit a panel in. Measure the remaining space and cut panel appropriately.

Typical Flooring Arrangement

Step 3. Stagger the Second row of OvrX so that the seams are off-set.

Level your Floor as you go using our OvrX leveling pads. Just slide the pad under the portion of the tile that is raised to eliminate excessive sagging.

If your floor has a slight slant the stiffness of OvrX flooring may eliminate the need for leveling. Test your floor as you go by walking on the tiles to find uneven spots that require leveling.

Installing carpet or vinyl